 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| DATA SHEET HY2004 120 WATTS The ILP HY2004 Power Amplifier is a fully encapsulated high quality power amplifier with Integral heatsink. By selecting the appropiate mains transformer and programming link the amplifier can be used with 4 or 8 loads with the automatic adjustment of input sensitivity. Mounting can be achieved by the use of T-slots in the heatsink and the nuts and bolts provided. TYPICAL SPECIFICATIONS Parameter Output Power Frequency Response (-3dB) Total Harmonic Distortion @ 1kHz Signal to Noise Ratio (DIN AUDIO) Slew Rate typical Rise Time Input Sensitivity Input Impedance Damping Factor(8 @ 100Hz) Load Impedance (programmable) Maximum D.C. rails (8 load) Size Width x Height x Extrusion Cut Weight Value 150W rms. Max 15Hz - 50kHz 0.005% 100dB 20V/S 5S 500mV rms. 100K >400 4 or 8 55V 120x75x80mm 835g * * * * * * * * FEATURES Programmable 4 or 8 operation Enhanced specifications Anti-thump Circuitry Integral heatsink Thermal Protection PTH Circuit Board Encapsulated POWER SUPPLY REQUIREMENTS ILP have developed a range of Hi-Fi quality Low noise Audio Power Toroidal Transformers for the HY2004 they are Low Profile with Resin filled centres for maximum noise absorption and ease of mounting. Finished in black to match the amplifiers these transformers are the ideal choice to power the HY2004. Mode 4 8 Transformer AT1204 AT1208 RMS Supply Voltage 32 - 0 - 32v 40 - 0 - 40v Size 110x50mm 110x50mm Weight 2.1Kg 2.1Kg SPONG LANE ELMSTED ASHFORD KENT TN25 5JU PHONE +44 (0)1233 750481 FAX +44 (0)1233 750578 ELECTRICAL / MECHANICAL DETAILS AND DIMENSIONS INSTALLATION NOTES For normal usage and conditions the amplifier needs no supplementary heatsink. It must be mounted to allow a vertical flow of air through the fins. No input capacitor is required. An internal 100V working capacitor is fitted. For loudspeaker protection it is recommended that a quickblow fuse is mounted between the output and the speaker. The fuse rating specified has been calculated to ensure fast rupture in the event of DC being presented to the speaker. It is advised not to use a higher rated fuse. 5. The amplifier module is supplied in 4 mode. To set 8 mode simply make a link between the two pads marked 'link'. 6. For 4 mode use a 3.15A quickblow fuse and for 8 a 2.5A quickblow fuse. 1. 2. 3. 4. |
Price & Availability of HY2004
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |